TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 388 of 785

INSTALL PERSONNEL HEATER KIT (M113A2 AND M1059 ONLY) — Continued

55. Connect heater inlet fuel line (15) to elbow (14) and elbow (16). Connect elbow (16) to elbow (11).

56. If required, use a hacksaw to trim ends of personnel seat (1) and seat back (2), so heater hose may be installed.

57. Secure left and right floor plates (3) to hull crossmembers with seven screws (4) and washers (5).

58. Align heater duct (6), washer (7), and shield (8) with front three holes in floor plates. Secure with three new screws (9)

and washers (10) from kit.

59. Secure one nipple (11) to plenum (12) with latch (13).

60. Secure one nipple (11) to duct (6) with latch (13).

61. Secure hose (14) to two nipples (11) with two clamps (15).

0055 00-11

0055 00

TM 9-2350-261-34