TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 413 of 785

TM 9-2350-261-34

INSTALL ELECTRONIC EQUIPMENT HEATER KIT (M577A2 ONLY) — Continued

0058 00

2.

Place bracket (1) under platform (2). Secure with two screws (3) and nuts (4).

3.

Remove nut (5), screw (6), and two washers (7) from platform (2).

4.

Place bracket (8) on the end of platform (2). Secure with screw (6), nut (5), and two washers (7) that were removed in

Step 3 above. Secure other end of bracket with screw (9) and nut (10).

5.

Place saddle (11) and ground lead (12) under bracket (8). Secure with screw (13), nut (14), and three washers (15).

Secure other end of saddle (11) with screw (13) and nut (14).

6.

Install one clamp (16) in saddle (11) and one clamp (16) in bracket (1).

WARNING

Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These

compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you

dizzy and irritate your eyes and throat.

Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.

Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.

7.

Apply a thin, even coat of primer and then sealing compound to external tapered pipe threads of heater fuel inlet nipple

(1)andadapter(2).Donotapplyprimerorsealing compound beyond small end of threads.

0058 00-2