TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 421 of 785

TM 9-2350-261-34

INSTALL ELECTRONIC EQUIPMENT HEATER KIT (M577A2 ONLY) — Continued

0058 00

37. Place electronic equipment heater fuel pump (9) on center floor support beam near rear of carrier. Secure with four

washers (10), two screws (11), and two nuts (12).

WARNING

Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These

compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you

dizzy and irritate your eyes and throat.

Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.

Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.

38. Apply a thin, even coat of primer and then sealing compound to external pipe threads of adapter (13). Do not apply

primer or sealing compound beyond small end of threads.

39. Install outlet elbow (14) and outlet adapter (13) on fuel pump (9).

40. Install fuel pump inlet adapter (15) on fuel pump (9).

41. Connect inlet hose (16) to inlet hose adapter (3) and inlet adapter (15).

0058 00-10