TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 423 of 785

TM 9-2350-261-34

INSTALL ELECTRONIC EQUIPMENT HEATER KIT (M577A2 ONLY) — Continued

0058 00

WARNING

Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These

compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you

dizzy and irritate your eyes and throat.

Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.

Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.

48. Apply a thin, even coat of primer and then sealing compound to external pipe threads of engine bulkhead elbow (1) and

transverse beam nipple (2). Do not apply primer or sealing compound beyond small end of threads.

49. Secure elbow (1) to power plant bulkhead with nut (3).

50. Install sleeve (4) and nut (5) on heater fuel inlet hose (6).

51. Connect fuel inlet hose (6) to elbow (1).

52. Disassemble bulkhead side of beam nipple (2). Install nipple in transverse engine compartment beam with nut (7).

53. Install sleeves (8) and (9) and nuts (10) and (11) on fuel hose (12).

54. Connect fuel hose (12) to elbow (1) and beam nipple (2).

0058 00-12