TM-9-2350-277-20-5

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL VOLUME 5 OF 6

TM-9-2350-277-20-5 - Page 532 of 1047

TM 9-2350-277-20-5

INSTALL/REMOVE BASE PLATE MOUNTING ADAPTORS WITH

ARMOR KIT INSTALLED (M1064A3 ONLY)

0751 01

THIS WORK PACKAGE COVERS:

Installation (page 0751 01-1).

Removal (page 0751 01-3).

INITIAL SETUP:

Maintenance Level

Unit

Tools and Special Tools

General Mechanic’s Tool Kit (WP 0926 00, Item 65)

Wrench Set, socket 3/4 inch (WP 0926 00, Item 73)

Personnel Required

Mechanic

Equipment Condition

Engine stopped (TM 9-2350-277-10)

Carrier blocked (TM 9-2350-277-10)

INSTALLATION

NOTE

Installation/removal for the mortar base plate mounting adaptors can only be used when the

side Armor Kit is installed without the Bar Armor Kit.

IfBarArmorKitistobeinstalled,donotinstallthisbase plate mounting adaptor kit.

1.

Remove two screws (3), flat washers (2), and brackets (1) if installed from left rear side of vehicle. Discard screws.

2.

Remove four screws (3) and flat washers (2) if installed from left rear side of vehicle. Discard screws.

075101-1

Change 5

Torque Wrench (WP 0926 00, Item 8

6

)