TM 9-2350-311-20-1
- Check all battery electrolyte levels.
- Clean all battery terminals.
- Check batteries’ specific gravities (para 8-28).
- Charge batteries if they haven’t already been charged.
- Clamp current probe, TK item 11, around battery cable that connects series pair of batteries.
Make sure current probe is closed.
- Point arrow on current probe toward negative post as shown in paragraph 1-11.
- Engage starter only long enough to briefly turn engine (approximately 1 second).
Refer to TM 9-4910-571-12&P for
offset fault isolation.
Figure 3, Sheet 10 of 36
I-36
Go to step 3, Figure 3,
sheet 24.