TM 9-2350-311-20-1
If display shows GO, check
cables and connections to
starter and repeat step 7,
Figure 3, sheet 20.
Go to step 4,
Figure 3, sheet 17
and perform test on
next battery.
After completing repair,
rerun GO CHAIN tests to
verify that problem is fixed
and that no other problems
exist. Start at GO 1 (Figure
2, sheet 1).
Check battery
connections and
repeat step 7, Figure 3,
sheet 20.
NOT E
If display shows .9.9.9.9,
clean and tighten
connections on battery
and repeat step 7, Figure
3, sheet 20.
If battery fails in freezing
weather, crank engine for 5
seconds and retest. This
will warm battery slightly.
- If battery has been charged, replace battery.
- Go to step 4, Figure 3, sheet 17 and
perform test on next battery.
After completing repair, rerun GO
CHAIN tests to verify problem has
been fixed and that no other
problems exist. Start at GO 1
(figure 2, sheet 1).
Figure 3, Sheet 21 of 36
I-47
NOTE