TM-9-2350-311-34-1

HULL, POWERPLANT, DRIVE CONTROLS, TRACKS, SUSPENSION, AND ASSOCIATED COMPONENTS: HOWITZER, MEDIUM, SELF-PROPELLED, 155MM

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

SEPTEMBER 1994

TM-9-2350-311-34-1 - Page 280 of 352

TM 9-2350-311-34-1

10-1 WINTERIZATION KIT INSTALLATION — CONTINUED

a. Installation — Continued

70

71

72

73

74

Slide rear insulation blanket (161) over batteries. Guide free end of rear battery ground lead (circuit 7) (160)

through grommet (162) in blanket and position rear of blanket under rear winterization box tab (163).

Place front insulation blanket (164) over batteries, position outer side of blanket under rear winterization box

side tab (165) and position slot on inner side of blanket over stud (166) on front box. Install flat washers (167)

and wing nut (168) to stud.

Install rear battery ground lead (circuit 7) (160) to bulkhead with two existing screws and two Iockwashers.

Reroute left headlight wiring harness (169) and place on top of two blankets (161 and 164).

Check plug (170) to ensure installation in petcock valve (171) of lower main coolant tube.

Bleed coolant system.

10-20