TM 9-2350-311-34-2
BEARING/RACE RING ASSEMBLY - CONTINUED
c. Inspection
NOTE
If helical compression springs were found in race ring assembly, replace with race ring spacers.
1
Inspect inner race (10) and outer race (5). Retap if threads are damaged. Remove minor nicks from race to
teeth with a fine stone. Replace entire bearing/race ring assembly (3) if inner race or outer race is cracked,
broken, distorted, or teeth are badly marred, chipped, or broken.
2
Inspect seal retainer (14) and seal (15). Replace bearing/race ring assembly (3) if seal retainer or seal are
cracked, worn, or damaged.
3
Inspect and measure bearing balls (16). Replace if pitted, out-of-round, or if diameter is less than 1.249 in-
ches (3.17 cm).
4
Inspect race ring spacers (18). Replace if damaged.
4-6