TM 9--2520--215--34
STEER CONTROL VALVE ASSEMBLY REPAIR – CONTINUED
0027 00
ASSEMBLY – Continued
7. With the valve (5) in the neutral position and the detent ball seated in the central groove of the steer lever shaft,
adjust the steer valve detent plunger nuts to obtain a 0.025 to 0.035 inch clearance at the point shown. Lock the
nuts (10) to the valve stems by peening the inside diameters of the nuts against the flattened sides of the valve
stems.
8. Install steer position indicator (4) and new external retaining ring (3) on steer control lever shaft (5).
9. Install two new annular gaskets (8) and two plugs (7). Torque plugs to 90 to 100 ft--lb (122 to 135.6 N
S
m).
10. Install two new preformed packings (16) on two plugs (15) and install in steer control valve body (2).
11. Secure plugs (15) in steer control valve body (2) with two new outer retaining rings (14).
07i082ma
.025 TO
.035 INCH
3
4
14
15
16
14
15
16
5
2
10
9
8
9
8
10
7
NOTE
FOLLOW--ON MAINTENANCE:
Install steer control valve assembly
(WP 0026 00)
END OF WORK PACKAGE
0027 00--5/6 blank