TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 290 of 508

TM 9--2520--215--34

0056 00--2

INPUT SCAVENGE OIL PUMP ASSEMBLY REPAIR – CONTINUED

0056 00

DISASSEMBLY – Continued

NOTE

Do not remove dowel pins from divider plate or needle bearings from pump, cover and body

unless replacement is required. Step 5 gives procedures for removal.

5. Press or drive needle bearings (10) out. Remove dowel pins (11) from divider plate (3).

11

3

10

10

CLEANING

See WP 0018 00 for cleaning procedures.

INSPECTION

See WP 0018 00 for general inspection and repair recommendations.

PART NAME

CHECK POINTS

ACCEPTABLE LIMITS

Needle bearings

Input scavenge pump body

Internal drive gear

Idler gear

Bearings OD

Bearings ID

Bore ID in pump body and cover

Bearing surface OD of gear shaft

Bearing fit on gears

Bearing surface OD of gear shaft

Bearing fit on gears

To press fit 1.2495 to 1.2505 bore

To fit 1.000 diameter shaft

1.2495 to 1.2505 in.

Wear limit: 1.2510 in.

0.9990 to 1.0000 in.

To fit on 1.0000 diameter shaft

0.9990 to 1.0000 in.

To fit on 1.0000 diameter shaft

ASSEMBLY

1. Install needle bearings (10) in cover assembly (2).

2

10

10