TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 417 of 508

TM 9--2520--215--34

0077 00--1

OUTPUT DRIVE SHAFT AND RELATED PARTS REPAIR

0077 00

THIS WORK PACKAGE COVERS:

Disassembly, Cleaning, Inspection, Fit and Wear Limits, Assembly

INITIAL SETUP:

Tools and Special Tools

General mechanic’s tool kit (item 1, WP 0088 00)

Arbor press (item 20, WP 0088 00)

Retaining ring pliers (item 21, WP 0088 00)

Torque wrench (item 26, WP 0088 00)

Torque multiplier (item 27, WP 0088 00)

Materials/Parts

Lumber (item 6, WP 0085 00)

Retaining ring (3) (item 29, WP 0087 00)

Retaining ring (2) (item 11, WP 0087 00)

Materials/Parts – Continued

Retaining ring (item 48, WP 0087 00)

White lead (item 13, WP 0085 00)

Equipment Conditions

Output drive shaft removed (WP 0075 00)

DISASSEMBLY

1. Remove four spanner nut lock rings (1) from four spanner nuts (2) on drive shaft (3). Discard lock rings.

2. Loosen (approximately four turns) spanner nut (2) which is against output pump drive gear (4).

3. Drive output bevel--driven gear (5) toward center of drive shaft (3) and remove snap ring (6) retaining gear.

Discard snap ring.