TM-9-2520-215-34

TM-9-2520-215-34 - Page 424 of 508

TM 9--2520--215--34

0077 00--8

OUTPUT DRIVE SHAFT AND RELATED PARTS REPAIR – CONTINUED

0077 00

ASSEMBLY

1. Install spanner nuts (2) over smaller diameter end of shaft. Thread first nut, chamfered side first, completely over

first threads on shaft, down far enough to thread second nut, chamfered side out, fully on to first threads.

2. Install coolant pump drive gears (14), recessed end first, over long--splined end of shaft (3). Position gear against

spanner nut (2).

3. Install large roller bearing (15), if removed. Coat gear (5) with white lead. Press bearing, large diameter first, onto

hub.

WARNING

Use tongs or gloves to prevent injury when handling heated parts.

4. Install bevel--driven gear (5), tooth side first, onto long--splined end of shaft (3). Press shaft (3) into gear (5) until

snap ring can be installed. Install new snap ring (6).

5. Tighten spanner nut (2) against oil pump gear (4) until output bevel--driven gear (5) is tight against snap ring (6)

and hole in spanner nut (2) aligns with slot in shaft.