TM-9-2520-238-34P
M113A1 FOV, M113A2 FOV, M548 AND M548A1
DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST (INCLUDING DEPOT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST); RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE
TM-9-2520-238-34P - Page 10 of 80
SECTION I
TM 9-2520-238-34P
6
(
5)
Part numbers for bulk materials are referenced in this column in the line item entry for the item to be
manufactured/fabricated.
(6)
When the item is not used with all serial numbers of the same model, the effective serial numbers
are shown on the last line(s) of the description (before UOC). Not applicable.
(7)
The usable on code, when applicable (see paragraph 5, Special Information).
(8)
In the Special Tools List section, the basis of issue (BOI) appears as the last line(s) in the entry for
each special tool, special TMDE and other special support equipment. When density of equipment supported
exceeds density spread indicated in the basis of issue, the total authorization is increased proportionately.
(
9)
The statement “END OF FIGURE” appears just below the last item description in Column 5 for a
given figure in both Section II and Section III.
f. QTY (Column (6)).
The QTY (quantity per figure column) indicates the quantity of the item used in the
breakout shown on the illustration figure, which is prepared for functional group, subfunctional group, or an
assembly. A ‘V’ appearing in this column in lieu of a quantity indicates that the quantity is variable and the
quantity may vary from application to application.
4.
Explanation of Columns (Section IV)
a. NATIONAL STOCK NUMBER (NSN) INDEX.
(1) STOCK NUMBER column.
This column lists the NSN by National Item Identification Number (NIIN)
sequence. The NIIN consists of the nine digits of the NSN.
NSN
NIIN
When using this column to locate an item, ignore the first 4 digits of the NSN. However, the complete NSN
should be used when ordering items by stock number.
(2) FIGURE NUMBER column.
This column lists the number of the figure where the item is
identified/located. The figures are in numerical order in Section II and Section III.
(3) ITEM NUMBER column.
The item number identifies the item associated with the figure listed in the
adjacent FIG. column. This item is also identified by the NSN listed on the same line.
b. PART NUMBER INDEX.
Part numbers in this index are listed by part number in ascending
alphanumeric sequence (i.e., vertical arrangement of letter and number combination which places the first
letter or digit of each group in order A through Z, followed by the numbers 0 through 9 and each following
letter or digit in like order.)
(1) CAGEC column.
The Commercial and Government Entity (CAGE) Code (C) is a 5-digit
alphanumeric code used to identify the manufacturer, distributor or Government agency, etc., that supplies
the item.
(2) PART NUMBER column.
Indicates the primary number used by the manufacturer (individual, firm,
corporation, or Government activity), which controls the design and characteristics of the item by means of its
engineering drawings, specifications, standards, and inspection requirements to identify an item or range of
items.
Back to Top
