TM-9-2520-238-34P
M113A1 FOV, M113A2 FOV, M548 AND M548A1
DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST (INCLUDING DEPOT MAINTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST); RIGHT ANGLE DRIVE, COOLING FAN; GEARCASE, TRANSFER; DRIVE ASSEMBLY, FINAL; DIFFERENTIAL, STEERING CONTROL; BRAKE, SINGLE DISK; CYLINDER ASSEMBLY, HYDRAULIC BRAKE
TM-9-2520-238-34P - Page 9 of 80
SECTION I
TM 9-2520-238-34P
5
(3) Recoverability Code.
Recoverability codes are assigned to items to indicate the disposition action on
unserviceable items. The recoverability code is entered in the
fifth
position of the SMR code as follows:
Recoverability
Application/Explanation
Code
Z
Nonreparable item. When unserviceable, condemn and dispose of the
item at the level of maintenance shown in 3rd position of SMR Code.
O
Reparable item. When uneconomically reparable, condemn and dispose
of the item at unit maintenance level or aviation unit level.
F
Reparable item. When uneconomically reparable, condemn and dispose
of the item at direct support level or aviation intermediate level.
H
Reparable item. When uneconomically reparable, condemn and dispose
of the item at general support level.
D
Reparable item. When beyond lower level repair capability, return to
depot. Condemnation and disposal of item not authorized below
depot level.
L
Reparable item. Condemnation and disposal of item not authorized below
Specialized Repair Activity (SRA).
A
Item requires special handling or condemnation procedures because
of specific reasons (e.g., precious metal content, high dollar value,
critical material, or hazardous material). Refer to appropriate manuals/
directives for specific instructions.
c. CAGEC (column (3)).
The Commercial and Government Entity Code (CAGEC) is a 5-digit
alphanumeric code which is used to identify the manufacturer, distributor, or Government agency, etc. that
supplied the item.
d. PART NUMBER (Column (4)).
Indicates the primary number used by the manufacturer (individual,
company, firm, corporation, or Government activity), which controls the design and characteristics of the item
by means of its engineering drawings, specifications, standards, and inspection requirements to identify an
item or range of items.
NOTE: When you use a NSN to requisition an item, the item you receive may have a different part number
from the part ordered.
e. DESCRIPTION AND USABLE ON CODE (UOC) (Column (5)).
This column includes the following
information:
(1)
The Federal item name and, when required, a minimum description to identify the item.
(
2
) Physical security classification. Not applicable.
(3)
Items that are included in kits and sets are listed below the name of the kit or set on Figure KIT.
(4)
Spare/repair parts that make up an assembled item are listed immediately following the assembled
item line entry.
Back to Top
