TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 455 of 933

TM 9-2520-270-34

9. INSTALL THREE WASHERS (1)

AND SCREWS (2) IN HOLES (3)

LOCATED BEHIND SPUR GEAR (4).

a. Rotate gear (4) to aline one of four

access holes (5) with one of three

screw holes (3).

b. Install new lock washer or old

flat washers (1) and screw (2) in

hole located behind gear (4).

c. Repeat steps 9a and 9b for remaining

two washers (1) and screws (2).

10. USING 1/2-INCH DRIVE TORQUE

WRENCH, TORQUE THREE SCREWS (2)

TO 45-50 ft-lb (6-7 mkg).

11. INSTALL DISCONNECT CLUTCH

ASSEMBLY. See task REPLACE

DISCONNECT CLUTCH ASSEMBLY,

page 4-78.

12. INSTALL DISCONNECT CLUTCH. See

task REPLACE DISCONNECT CLUTCH,

page 4-52.

END OF TASK

Change

1

4-143