TM-9-2520-270-34
HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY
TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE
NOVEMBER 1984
TM-9-2520-270-34 - Page 445 of 933
TM 9-2520-270-34
NOTE
Tube has a large opening and a small opening.
Use small opening to slant ring onto guide.
Use large opening to move it onto flat
shoulder of guide.
58. PRESS NEW RETAINING RING (1)
ONTO SNAP RING GUIDE (2).
a.
b.
c.
d.
e.
Place wood block (Item 1) in
arbor press.
Place guide (2) on block.
Put new retaining ring (1) on
guide (2).
Set snap-ring guide tube (3) on new
retaining ring (1).
Using tube (3), press new retaining
ring (1) onto guide (2) until seated
on shoulder (4). Remove from arbor
press.
59. INSTALL NEW RETAINING RING (1).
a. Place guide (2) with new retaining
ring (1) on spline (5).
b. Slide tube (3) on guide (2).
c. Using plastic-faced hammer, tap
tube (3) until new retaining ring (1)
slides off guide (2) into retaining
ring groove (6).
END OF TASK
Change 1
4-137
Back to Top
