TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 440 of 933

TM 9-2520-270-34

NOTE

If bevel gear or pinion is damaged, both gears

must be replaced as a matched set.

31. INSPECT BEVEL GEAR (1).

a.

b.

c.

d.

Inspect gear (1) for excessive wear

or damage. See page 2-5.

If gear (1) is worn or damaged,

and gear (2) or cone and rollers (3)

were not removed, do steps 23 and 24.

Go to step 32.

If gear (1) is worn or damaged, and

gear (2) or cone and rollers (3)

were removed, go to step 32.

If gear (1) is not worn or damaged,

go to step 35.

32. DISCARD BEVEL GEAR (1).

33. REMOVE SPIRAL BEVEL PINION (4)

WITH CONE AND ROLLERS (5)

FROM GEARSHAFT (6), IF NOT

REMOVED.

a. Using mechanical puller kit, remove

pinion (4) from gearshaft (6).

34. REPLACE PINION (4) AND CONE

AND ROLLERS (5).

34.1

IF HOUSING (7) WAS NOT

REPLACED, INSPECT INSERTS. See

page 2-5.

a. Repair inserts if damaged. See

task REPAIR INPUT BEVEL

HOUSING INSERTS, page 4-138.

4-132

Change

2