TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 438 of 933

TM 9-2520-270-34

19. REMOVE GEAR (1).

a. Using arbor press, remove gear (1).

20. DISCARD BEVEL GEAR SHAFT (2).

21. REPLACE PINION. See task REPLACE

INPUT BEVEL ASSEMBLY, page 4-94.

23. REMOVE CONE AND ROLLERS (3)

IF NOT REMOVED.

a. Insert drift punch through holes (4)

in gear shaft (2) and evenly tap

off cone and rollers (3).

b. Discard cone and rollers (3).

24. REMOVE GEAR (1) IF NOT REMOVED.

a. Using arbor press, remove gear (1).

25. DISCARD GEAR (1).

NOTE

Cone and rollers and spur gear may have been

removed.

22. INSPECT GEAR (1).

a. Inspect gear (1) for damage. See

page 2-5.

b. If gear (1) is damaged, go to step 23.

If not, go to step 26.

26. INSPECT OUTER ROLLER CUP (5)

IN HOUSING ASSEMBLY (6).

a.

b.

Inspect cup (5) for damage. See

TM 9-214.

If cup (5) is damaged or cone and

rollers were discarded in step 8, cup

must also be discarded. Go to step 27.

If cup is not damaged, go to step 28.

4-130