TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 443 of 933

48. INSTALL GEAR ASSEMBLY (1).

a. Place housing assembly (2) over gear

assembly (1).

49. INSTALL CONE AND ROLLERS (3),

SMALL END FIRST. INSTALL

WASHER (4), NEW KEY WASHER (5),

AND NUT (6).

50. PLACE HOUSING ASSEMBLY (2)

ON TWO WOOD BLOCKS (ITEM 6).

a. Put blocks under outside edge

of housing assembly (2).

51. USING BEARING NUT WRENCH, DRAG

WRENCH, AND HINGED HANDLE,

TIGHTEN NUT (6).

a. (H) Hold housing assembly (2).

b. Tighten nut (6) a little with bearing

nut wrench.

52. USING 3/8-INCH DRIVE TORQUE

WRENCH WITH ADAPTER AND

DRAG WRENCH, CHECK

BEARING DRAG.

a. (H) Hold housing assembly (2).

b. Turn torque wrench slowly one full

turn. If torque is 15-20 in-lb

(17-23 cmkg), go to step 53.

c. If torque is less than 15 in-lb

(17 cmkg), go to step 51. If torque

is more than 20 in-lb (23 cmkg),

loosen nut (6), then go to step 51.

GO TO NEXT PAGE

Change 1

4-135

TM 9-2520-270-34