TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 437 of 933

TM 9-2520-270-34

14. INSPECT GEAR

a. Inspect gear

page 2-5.

(1).

(1) for damage. See

b. Discard gear (1) if damaged.

15. GO TO STEP 26.

17. REMOVE CONE AND ROLLERS (2).

a.

b.

Insert drift punch through holes (3) in

gear shaft (4) and evenly tap off cone

and rollers (2).

Discard cone and rollers (2).

NOTE

If either cone or rollers is damaged, both

must be discarded.

16. INSPECT CONE AND ROLLERS (2).

a. Inspect cone and rollers (2) for

damage. See TM 9-214.

b. If cone and rollers (2) are damaged,

go to step 17. If not, go to step 22.

18. CHECK BEVEL GEAR SHAFT (4).

a. Using micrometer caliper set,

measure outside diameter of shaft (4).

b. If measurement of shaft (4) is less

than 3.3765 inches (85.763 mm), go to

step 19. If not, go to step 22.

GO TO NEXT PAGE

4-129