TM-9-2520-270-34
HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY
TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE
NOVEMBER 1984
TM-9-2520-270-34 - Page 515 of 933
TM 9-2520-270-34
9. INSPECT SPINDLE (1).
a. Inspect spindle (1) for damage. See
page 2-5.
b. If spindle (1) is damaged, go to
step 10. If not, go to step 12.
10. REPAIR RIGHT-HAND SINGLE
DISK BRAKE, page 4-202.
11. GO TO STEP 13.
a.
b.
13. INSPECT BORE (4) OF
SPUR GEAR (5).
Inspect bore (4) of spur gear (5) for
grooves, scoring, and scratches.
If bore (4) is damaged, go to step 18.
If not, go to step 14.
12. INSPECT FOUR PADS (2) ON
PISTON ASSEMBLIES (3).
a. Inspect four pads (2) for damage. See
page 2-5.
b. If pads (2) are not damaged, go to
step 13. If any pads are damaged,
replace all piston assemblies (3). See
task REPAIR RIGHT-HAND SINGLE
DISK BRAKE, page 4-202.
14. INSPECT CLUTCH DISK (6) ON
SPUR GEAR (5).
a. Remove disk (6) and inspect both
sides for damage. See page 2-5.
b. If disk (6) is damaged, replace it
and go to step 15. If not, go to
step 14.1
GO TO NEXT PAGE
Change 2
4-198.1 (4-198.2 blank)
Back to Top
