TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 506 of 933

TM 9-2520-270-34

42. INSTALL TWO PLUGS (1).

a. Coat two new preformed packings (2)

with engine oil. Install packings on two

plugs (1).

b. Install two plugs (1).

43

USING 3/8-lNCH DRIVE TORQUE

WRENCH AND 3/16-lNCH SOCKET

WRENCH ATTACHMENT, TORQUE TWO

PLUGS (1) TO 110-120 in-lb

(127-138 cmkg).

44. REPAIRER AND HELPER TURN

HOUSING (3) OVER AND PLACE ON

WOOD BLOCKS.

45. INSTALL FOUR NEW BRAKE PADS (4).

a. If pads (4) were discarded, replace with

new pads. If pads were not discarded,

go to step 47.

b. Position four pads (4) from underside of

housing (3). Rotate pads until hole in

pad alines with screw hole in housing.

c. (H) Using 1-inch drive ratchet handle

and 1 3/4-inch socket, hold pads (4).

Install four washers (5) and screws (6).

46. USING 1/2-lNCH DRIVE TORQUE

WRENCH, TORQUE FOUR SCREWS (6)

TO 40-45 ft-lb (6 mkg).

4-192

Change 4