TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 496 of 933

48. REMOVE RETAINING RING (1)

AND SHIM (2).

a. (H) Reach in through controller

opening (3) and pry up cross

shaft (4).

c.

Remove shim (2).

49.SELECT NEW SHIM (2) FROM

SHIM KIT.

a.Using

micrometer

calipler

set ,

select

new shim (2) from shim kit that will

give a gap of 0.02B-0.037 inch

(0.71-0.1.94 mm).

4-182

b.

Using retaining-ring

pliers, remove

retaining ring (1).

WARNING

use

care when removing

retaining ring. Personnel can

be injured. Always wear

goggles.

END OF TASK

50. INSTALL NEW SHIM (2) .

51. INSTALL RETAINING RING (1).

a. (H) Reach in through controller

opening (3) and pry up cross

shaft (4).

b. Using retaining-ring pliers, install

retaining ring (1)

c. Go to step 47.

52. INSTALL LEFT-HAND OUTPUT

HOUSING. See task REPLACE

LEFT-HAND OUTPUT HOUSING,

page 4-314.

53. INSTALL CONTROLLER ASSEMBLY

See task REPLACE CONTROLLER

ASSEMBLY, page 3-32.

TM 9-2520-270-34