TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 504 of 933

TM 9-2520-270-34

33. CHECK BEARING BORE (1).

I

34. CHECK BEARING BORE (2).

a. Using telescoping gage set and

micrometer caliper set, measure inside

diameter of bore (1).

b. If measurement is greater than

5.9051 inches (150.000 mm), go to

step 39. If not, go to step 34.

a. Using telescoping gage set and

micrometer caliper set, measure inside

diameter of bore (2).

b. If measurement is greater than 4.5290

inches (115.037 mm), go to step 39. If

not, go to step 35.

35. CHECK Mechanical HOUSING (3).

a. Using micrometer caliper set, measure

outside diameter of mechanical

housing (3).

b. If measurement is less than

3.1478 inches (79.954 mm), go to

step 39. If not, go to step 36.

4-190

Change 4