TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 500 of 933

TM 9-2520-270-34

13. REMOVE AND DISCARD RETAINING

RINGS (1) FROM TOW PUMP SPUR

GEARS (2).

a. Using screwdriver, remove and discard

two retaining rings (1).

15. INSPECT NEEDLE ROLLER BEARINGS (4)

IN TWO GEARS (2).

a. Inspect bearings (4) for damage. See

TM 9-214.

b. If either bearing (4) is damaged, go to

step 16. If not, go to step 18.

14. REMOVE TWO GEARS (2).

a. Remove two thrust washers (3) and two

gears (2).

b. Remove remaining two thrust

washers (3).

16. REMOVE BEARING (4) FROM GEAR(S) (2).

a. Using arbor press and bearing installer,

(Item 12), remove bearing (4) from

bottom side of gear (2). Discard

bearing.

4-186

Change 4