TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 495 of 933

TM 9-2520-270-34

45. INSTALL RETAINING RING (1).

a. (H) Reach in through controller

opening (2) and pry up cross

shaft (3).

b. Using retaining-ring pliers, install

retaining ring (1).

46.

47.

INSTALL RIGHT-HAND OUTPUT

HOUSING. See task REPLACE

RIGHT-HAND OUTPUT HOUSING,

page 4-270.

MEASURE GAP BETWEEN RETAINING

RING (1) AND SHIM (4).

a. Position transmission with left

side up.

b. (H) Reach in through controller

opening (2) and pry up cross

shaft (3).

c. Measure gap between retaining

ring (1) and shim (4). Lower

d.

cross shaft (3).

If gap is 0.028-0.037 inch

(0.71-0.94 mm), go to step 52.

If not, go to step 48.

GO TO NEXT PAGE

4-181

WARNING

Use care when installing

retaining ring. Retaining ring

can fly. Personnel can be

injured.

Always wear goggles.