TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 498 of 933

TM 9-2520-270-34

4. CHECK CLUTCH DISK (1).

a.

b.

c.

d.

Using micrometer caliper set, measure

thickness of disk (1) in three places.

Replace disk (1) if thickness is less than

0.150 inch (3.81 mm).

Using flat surface and feeler gage,

check disk (1) for warpage. Check

inside and outside edges in three

places.

Replace disk (1) if warpage is greater

than 0.010 inch (0.25 mm).

NOTE

Ball bearings might not come out with gear.

One bearing may stay in Intermediate housing.

The other bearing may stay in single disk

brake.

6. INSPECT TWO BALL BEARINGS (4).

a.

b.

4-184

Inspect bearings (4) on each end of

gear (2) for damage. See TM 9-214.

If either bearing (4) is damaged, go to

step 7. If not, go to step 9.

Change 2

5. REMOVE GEAR (2).

a. Using pry bar, pry out gear (2).

b.

(Deleted)

7. REMOVE DAMAGED BEARING(S) (4).

a. Using mechanical puller kit, remove

damaged bearing(s) (4). Discard

bearing(s).