TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

  TM-9-2520-270-34 - Page 812 of 933

TM 9-2520-270-34
CAUTION
Keep eccentric ring and outer rotor together
when removing from housing. Spring and vane
can be lost and equipment can be damaged.
7. PULL OUT RING (1) AND OUTER
ROTOR (2) FROM LIQUID PUMP
HOUSING (3) AS ONE UNIT.
10. CHECK INSIDE DIAMETER OF PUMP
HOUSING CAVITY (6).
a.
b.
4-476
Using telescoping gage set and
micrometer caliper set, measure
diameter of cavity (6).
If measurement is greater than
3.8775 inches (98.489 mm), go to
step 12.1, If not, go to step 11.
Change 2
8.
9.
IF OUTER ROTOR (2) AND
RING (1) HAVE COME APART, GO TO
STEP 9. IF NOT, GO TO STEP 10.
ASSEMBLE OUTER ROTOR (2)
AND RING (1)
a. Install spring (4) and vane (5) into
rotor (2).
b. While holding spring (4) and vane (5)
with thumb, insert rotor (2) into
ring (1).
11. CHECK INSIDE DIAMETER OF
SLEEVE BEARING (7).
a. Using telescoping gage set and
b.
micrometer caliper set, measure
inside diameter of bearing (7).
If measurement is greater than
1.002 inches (25.45 mm), go to
step 12.1. If not, go to step 12.


Back to Top