TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

  TM-9-2520-270-34 - Page 802 of 933

TM 9-2520-270-34
NOTE
Bearing on same side of cast depression is
normally loose and must be removed first.
5. REMOVE AND DISCARD BEARING (1)
ON SAME SIDE AS CAST
DEPRESSION (2).
7. CHECK STRAIGHT SHAFT (5).
a. Using micrometer caliper set,
measure outside diameter of bearing
surface (6).
b. Replace straight shaft (5) if meas-
urement is less than 2.1637 inches
(54.958 mm).
8. CLEAN CROSS SHAFT ASSEMBLY.
a. Clean straight shaft and piece parts.
See page 2-2.
9. INSPECT CROSS SHAFT ASSEMBLY.
a. Inspect straight shaft and piece
parts. See page 2-5.
6. REMOVE AND DISCARD BEARING (3).
a. Place housing (4) on two wood
blocks with cast depression (2)
up. Do not place blocks in way of
bearing (3).
b. Using drive punch and hammer,
remove and discard bearing (3).
4-466


Back to Top