TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 801 of 933

2. DISASSEMBLE CROSS SHAFT

ASSEMBLY (1).

a. Remove key washer (2).

b. Using mechanical puller kit, remove

bearing unit housing (3).

c. Remove spring washer (4), ring

spacer (5), and second spring

washer (4).

d. Discard two spring washers (4).

3. INSPECT BALL BEARINGS (6) AND (7).

a. Inspect bearings (6) and (7) for

damage. See TM 9-214.

b. If bearings (6) and (7) are not

damaged, go to step 4.

c. If either bearing (6) or (7) is

damaged, go to step 5.

4. CHECK BEARINGS (6) AND (7).

a. Using telescoping gage set and micro-

meter caliper set, measure inside

diameter of bearings (6) and (7).

b. If either measurement is greater than

2.1659 inches (55.014 mm),

go to

step 5.

c. If measurement is 2.1659 inches

(55.014 mm),

or less, go to step 7.

GO TO NEXT PAGE

4-465

TM 9-2520-270-34