TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 791 of 933

TM 9-2520-270-34

Encased seal consists of a seal and two backup

rings.

15. INSTALL NEW SEAL (1) ON

PLUG (2)

a. Coat new seal (1) with transmission

oil.

b. Position new seal (1) in groove (3).

c. Install two backup rings (4) so that

slots are about 180° apart.

WARNING

Do

not

handle

hot

or

cold

parts

without protective gloves.

Personnel can be injured.

CAUTION

Slot in plug must be alined with setscrew hole

or plug can be damaged.

16. INSTALL PLUG (2).

a. Place assembly (5) and piston (6) in

oven. Heat to 300° F (150° C) for

30 minutes. Using gloves, remove

from oven.

b. Aline slot (7) in plug (2) with

setscrew hole (8).

c. Push plug (2) into piston (6).

Change 1

4-455

NOTE

GO

TO

NEXT

PAGE