TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 792 of 933

TM 9-2520-270-34

17. SCREW SLIDE HAMMER ADAPTER (1)

INTO PLUG (2).

18. PLACE RETAINING RING (3) ON

PLUG (2) WITH SHARP EDGE

FACING OUT.

19. USING ARBOR PRESS, APPLY

PRESSURE TO ADAPTER (1) TO MOVE

PLUG (2) BELOW RETAINING

RING SLOT (4).

21.

22.

23.

SEAT PLUG (2)

a.

b.

c.

d.

Place assembly (5) in vise.

Thread slide hammer (6) into

adapter (1).

Pull out plug (2) until it seats against

retaining ring (3). Remove adapter (1).

Coat setscrew (7) with sealant

compound and install.

USING 1/4-lNCH DRIVE TORQUE

WRENCH AND 3/32-lNCH SOCKET

WRENCH ATTACHMENT, TORQUE

SETSCREW (7) TO 10-15 in-lb

(12-17 cmkg).

REMOVE ASSEMBLY (5) FROM

VISE

CAUTION

Seat retaining ring firmly in groove. Damage

to equipment can occur if ring is not properly

seated.

20. INSTALL RETAINING RING (3).

a. Using retaining-ring pliers, install

retaining ring (3) with sharp

edge out.

b. Release pressure and remove

assembly (5) from press.

END OF TASK

4-456

Change 1