TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 803 of 933

ASSEMBLE

NOTE

Spring washers must be installed with cupped

face toward spacer.

10. INSTALL NEW SPRING WASHER (1),

RING SPACER (2), AND SECOND NEW

SPRING WASHER (1).

NOTE

Sealant compound will harden In approximately

15 minutes at room temperature. Steps 12

through 18 must be completed before compound

sets up. If compound hardens before parts are

assembled, parts will have to be disassembled

and cleaned and assembly repeated.

12. APPLY SEALANT COMPOUND TO

INNER RACE (8) OF BEARING (3).

a.

b.

Apply a light coating of sealant com-

pound to outer half of inner race (8)

of bearing (3). Bearing is on same

side of housing (5) as cast

depression (6).

Using wiping rag, wipe off excess

sealant compound.

NOTE

Bearings are the same and will fit either side of

housing.

11. INSTALL NEW BEARINGS (3) AND (4).

a. If bearings (3) and (4) were removed,

go to step 1lb. If bearings were not

removed, go to step 12.

b. Using arbor press, press bearing (4)

into housing (5) opposite cast

depression (6) until seated against

shoulder (7).

c. Turn housing (5) over.

d. Push bearing (3) into housing (5)

until seated against shoulder (7).

CAUTION

Do not install housing with cast depression

facing spring washers or equipment damage

will result.

13. INSTALL HOUSING (5).

a. Install housing (5) with bearing (3)

and cast depression (6) facing away

from spring washer (1).

b. Using wiping rag, wipe off any sealant

compound on straight shaft (9).

GO TO NEXT PAGE

4-467

TM 9-2520-270-34