TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 134 of 620

TM 9-2520-272-40

0017

23.Turn right cover assembly (Figure 14, Item 1) over, outside up.

24.Apply petrolatum and lubricating oil to outer diameter of two brake apply shaft bearings (Figure 14, Item 2)

and (Figure 14, Item 3).

NOTE

Press brake apply shaft bearings with driver against numbered side of bearings.

25.Install two brake apply shaft bearings (Figure 14, Item 2) and (Figure 14, Item 3) in right cover assembly (Figure

14, Item 1). Push brake apply shaft bearings 0.030 to 0.040 in. (0.762 to 1.016 mm) in from brake apply shaft

seal (Figure 14, Item 4) and (Figure 14, Item 5) shoulders.

NOTE

Install brake apply shaft seal with numbered side of seal against seal inserter.

Small end of seal inserter tool is used for brake apply shaft seals.

Brake apply shaft seal contains dry-type sealer on outer edge.

26.Install brake apply shaft seals (Figure 14, Item 4) and (Figure 14, Item 5) in right cover assembly (Figure 14,

Item 1) using seal inserter. Push brake apply shaft seals to 0.080 in. (2.032 mm) below surface of right

cover assembly.

WARNING