TM-9-2520-272-40
CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A
TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL
FEBRUARY 2012
TM-9-2520-272-40 - Page 129 of 620
TM 9-2520-272-40
0017
27.Turn right cover assembly (Figure 8, Item 1) over, outside up.
28.Remove 3/8 in. pipe plug (Figure 8, Item 18).
29.Remove two 1/8 in. pipe plugs (Figure 8, Item 16) and (Figure 8, Item 17).
30.Remove 1/4 in. pipe plug (Figure 8, Item 15).
31.Remove 3/8 in. pipe plug (Figure 8, Item 19).
32.Check right cover assembly bearing bore for damage. Smooth out scratches with crocus cloth. If grinding
damage is present, replace right cover assembly.
CAUTION
When using grinder, use care as not to damage housing when cutting slots into sleeve.
NOTE
Remove sleeve only if sleeve is visibly damaged or when reworking housing due to damage to
the output seal area.
33.Cut two slots 180 degrees apart in sleeve (Figure 8, Item 14).
34.Break sleeve (Figure 8, Item 14) at slots. Discard sleeve (Figure 8, Item 14).
Back to Top
