TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 269 of 620

TM 9-2520-272-40

0033

CAUTION

Damage to left cover assembly can occur if excessive force is used. Do not force the cover

to seat on the transmission. Do not beat on it with a hammer or use the split line bolts to pull

it into position. If the cover seems to be hung up and will not properly install, remove the left

cover assembly from the transmission and verify that the correct bevel gear driven shaft is

installed. Conf rm that the part identif cation and length of bevel gear driven shaft matches that

which you have previously recorded during Replace Bevel Gear Drive Shaft and Filter Tubes,

WP 0038. This should be P/N 29533537, with length 10.65 in. (270.51 mm), used with rear

carrier assembly P/N 29533535.

12.Tap left cover assembly (Figure 8, Item 1) to seat cover against gasket on center housing assembly.

13.Torque two bolts (Figure 8, Item 4) and 29 bolts (Figure 8, Item 2) to 27 to 32 lb-ft (37 to 43 N·m).