TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 298 of 620

TM 9-2520-272-40

0038

REMOVE BEVEL GEAR DRIVEN SHAFT AND FILTER TUBES

CAUTION

Left cover assembly can be damaged if incorrect bevel gear driven gear shaft is installed.

Record part number of bevel gear driven shaft when removed.

NOTE

It may be necessary to move bevel gear driven shaft back and forth to remove it from

transmission.

1. Remove bevel gear driven shaft (Figure 1, Item 1) and record part number.

NOTE

The f lter-in tube is 3.60 in. (91.44 mm) long. The f lter-out tube is 2.25 in. (57.15 mm) long.

The f lter-out tube (shorter tube) is located near the input housing.

2. Remove f lter-in tube (Figure 1, Item 3) and f lter-out tube (Figure 1, Item 4) from center housing assembly

or from end cover.

3. Remove four packings (Figure 1, Item 2) from tubes (Figure 1, Item 3) and (Figure 1, Item 4). Discard four

packings (Figure 1, Item 2).

4. Remove packing (Figure 1, Item 5) from end of jumper tube (Figure 1, Item 6). Discard packing (Figure

1, Item 5).