TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 299 of 620

TM 9-2520-272-40

0038

INSTALL FILTER TUBES

1. Install new packing (Figure 2, Item 5) on end of jumper tube (Figure 2, Item 6).

2. Apply petrolatum to new packing (Figure 2, Item 5).

3. Install four new packings (Figure 2, Item 2), two packings on f lter-in tube (Figure 2, Item 3) and two packings

on f lter-out tube (Figure 2, Item 4).

4. Apply petrolatum to four new packings (Figure 2, Item 2).

NOTE

The f lter-in tube is 3.60 in. (91.44 mm) long.

The f lter-out tube is 2.25 in. (57.15 mm) long.

The f lter-out tube (shorter tube) is installed closest to the input housing.

5. Install f lter-out tube (Figure 2, Item 4) in center housing assembly (Figure 2, Item 7), top or bottom end of

tube in f rst.

6. Install f lter-in tube (Figure 2, Item 3) in center housing assembly (Figure 2, Item 7), top or bottom end of

tube in f rst.