TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

  TM-9-2520-272-40 - Page 308 of 620

TM 9-2520-272-40
0039
NOTE
When you attach the multiple-leg sling to three studs at approximately equal distances apart,
there will be seven studs between sling lugs in two places and eight studs between sling
lugs in one place.
19.Put three lugs of the multiple-leg sling (Figure 8, Item 25) over studs (Figure 8, Item 21) that are at equal
distances apart on the converter pump assembly (Figure 8, Item 17), and install three 5/16-24 inch hex nuts
(Figure 8, Item 22) and three 5/16 inch washers (Figure 8, Item 23). Tighten the nuts with your f ngers.
20.Tap on the converter pump assembly (Figure 8, Item 17) as you pull up on the pump with the multiple-leg sling
(Figure 8, Item 25). Remove the converter pump assembly (Figure 8, Item 17).
21.Remove three 5/16-24 inch hex nuts (Figure 8, Item 22), three 5/16 inch washers (Figure 8, Item 23), and the
multiple-leg sling (Figure 8, Item 25) from the converter pump assembly (Figure 8, Item 17).


Back to Top