TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 420 of 620

TM 9-2520-272-40

0052

Install Fourth and Reverse Clutch Housing Assembly Components

1. Install new outer seal (Figure 2, Item 9) and new inner seal (Figure 2, Item 10) onto the piston (Figure 2, Item

8). Apply petrolatum to the seals (Figure 2, Item 9) and (Figure 2, Item 10).

2. Apply a thin layer of petrolatum to the surface of the clutch housing (Figure 2, Item 11).

3. Install inner seal protector (Figure 2, Item 14) on ther hub of the housing assembly (Figure 2, Item 11). Lightly

apply petrolatum to the inner seal protector (Figure 2, Item 14).

4. Install the piston (Figure 2, Item 8) into the clutch housing (Figure 2, Item 11) so that the spring holes point up.

5. Remove the inner seal protector (Figure 2, Item 14).

6. Install 16 springs (Figure 2, Item 7) into the spring holes in the piston (Figure 2, Item 8).

7. Install the retaining plate (Figure 2, Item 5) on the springs (Figure 2, Item 7).

8. Put the retaining ring (Figure 2, Item 5) in position on the retaining plate (Figure 2, Item 6).

9. Compress the retaining plate (Figure 2, Item 6), using wrench, the bar and stud assembly (Figure 2, Item

13), and the clutch compressor (Figure 2, Item 12), against spring force to get access to the groove for the

retaining ring (Figure 2, Item 5).

10.Install the retaining ring (Figure 2, Item 5).

0052

‐

4