TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 428 of 620

TM 9-2520-272-40

0053

Assemble Clutch Piston Housing Assembly

1. Install the piston (Figure 3, Item 8) into the piston housing (Figure 3, Item 4). Do not install new seals (Figure 3,

Item 1) and (Figure 3, Item 3) at this time.

2. Install 12 springs (Figure 3, Item 7) into spring holes in the piston (Figure 3, Item 8).

3. Install the spring retainer (Figure 3, Item 5). Align the spring retainer (Figure 3, Item 5) with notches in the

piston housing (Figure 3, Item 4).

4. Install four new push-on nuts (locking rings) (Figure 3, Item 6) using the lock ring installer.

5. Remove the piston assembly (Figure 4, Item 2) from the piston housing (Figure 4, Item 4).

6. Install new seals (Figure 4, Item 1) and (Figure 4, Item 3) on the piston assembly (Figure 4, Item 2) so that the

seal lips point down. Apply petrolatum to seals (Figure 4, Item 1) and (Figure 4, Item 3).

7. Apply a thin layer of petrolatum to the touching surfaces of the piston housing (Figure 4, Item 4).

8. Install the piston assembly (Figure 4, Item 2) into the piston housing (Figure 4, Item 4).