TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 431 of 620

TM 9-2520-272-40

0054

SUSTAINMENT MAINTENANCE

REPLACE INPUT SHAFT COMPONENTS

INITIAL SETUP:

Tools and Special Tools

Pliers Set, Retaining Ring (WP 0079, Item 27)

Press, Arbor, Hand, 25 Ton (WP 0079, Item 28)

Tool Kit, General Mechanic’s (GMTK) (WP 0079,

Item 45)

Materials/Parts

Petrolatum, Technical (Petroleum Jelly) (WP 0078,

Item 12)

Seal Ring, Metal (WP 0080, Item 19) (2)

Personnel Required

Track Vehicle Repairer, 91H10

Equipment Condition

Transmission removed from vehicle or container (TM

9-2350-277-13&P)

Oil f ll tube assembly removed (WP 0006)

Second clutch piston housing assembly removed

(WP 0053)

REPLACE INPUT SHAFT COMPONENTS

Disassemble Input Shaft Components

1. Remove two seal rings (Figure 1, Item 1) from the range input shaft (shouldered shaft) (Figure 1, Item

2). Discard seal rings (Figure 1, Item 1).

2. Remove the retaining ring (Figure 1, Item 4).

3. Remove the front internal gear (Figure 1, Item 3) from the range input shaft (Figure 1, Item 2).

4. Remove the range input shaft (Figure 1, Item 2) with its attached parts from the rear carrier drum (Figure

1, Item 5).

5. Remove the center carrier (Figure 1, Item 6) from the input shaft (Figure 1, Item 2).