TM-9-2520-272-40
CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A
TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL
FEBRUARY 2012
TM-9-2520-272-40 - Page 84 of 620
TM 9-2520-272-40
0010
INSTALL LOCKUP CONTROL VALVE ASSEMBLY
CAUTION
Transmission must be in upright position when oil transfer gasket, oil transfer plate assembly,
separator plate, and control valve assemblies are installed. If transmission is not in vertical
position when these items are installed, misalignment of holes can block oil f ow, causing
malfunction of transmission.
Care should be taken not to let dust get into control valve assemblies. Keep top of transmission
center housing assembly clean. Keep all parts clean. Wipe with batiste cloth. Contamination of
control valves can cause transmission failure.
1. Install two 5/16-20 x 2-1/4 inch bolts (Figure 2, Item 1) and washers (Figure 2, Item 2) that attach lockup control
valve assembly (Figure 2, Item 4) to separator plate (Figure 2, Item 5).
2. Install four 5/16-18 x 2-3/4 inch bolts (Figure 2, Item 3) and washers (Figure 2, Item 2) that attach lockup control
valve assembly (Figure 2, Item 4) to separator plate (Figure 2, Item 5).
3. Torque six bolts (Figure 2, Item 1) and (Figure 2, Item 3) to 17 to 20 lb-ft (23 to 27 N·m).
Back to Top
