TM-9-2520-272-40
CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A
TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL
FEBRUARY 2012
TM-9-2520-272-40 - Page 89 of 620
TM 9-2520-272-40
0012
INSTALL PRIORITY VALVE ASSEMBLY
CAUTION
Transmission must be in upright position when oil transfer gasket, oil transfer plate assembly,
separator plate, and control valve assemblies are installed. If transmission is not in vertical
position when these items are installed, misalignment of holes can block oil f ow, causing
malfunction of transmission.
Care should be taken not to let dust get into control valve assemblies. Keep top of transmission
center housing assembly clean. Keep all parts clean. Wipe with batiste cloth. Contamination of
control valves can cause transmission failure.
1. Install two 1/4-18 x 2-1/8 inch bolts (Figure 2, Item 1) and two washers (Figure 2, Item 2) that attach priority
valve assembly (Figure 2, Item 5) to separator plate (Figure 2, Item 4).
2. Install 1/4-18 x 1-3/4 inch bolt (Figure 2, Item 3) and washer (Figure 2, Item 2) that attach priority valve
assembly (Figure 2, Item 5) to separator plate (Figure 2, Item 4).
3
. Torquethreebo
l
ts(F
igure2
,I
tem1)and(F
igure2
,I
tem3)to9to11lb-
f
t(12to15N·m)
.
Back to Top
