TM-9-2520-272-40
CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A
TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL
FEBRUARY 2012
TM-9-2520-272-40 - Page 97 of 620
TM 9-2520-272-40
0014
NOTE
Connectors on wiring harness are identif ed by stamped letters on connectors. Each connector
will have one of the letters A through G.
Use of twine is not necessary if all transmission top components are to be completely removed.
5. Tie a 30 in. (762 mm) piece of twine (Figure 2, Item 11) to harness connector F or G.
6. Remove wiring harness (Figure 2, Item 9). When wiring harness has been removed from the transmission, cut
the 30 in. (762 mm) piece of twine (Figure 2, Item 11) off the connector, leaving the twine installed through the
harness bore. When installing or replacing the harness, tie the outside end of the twine to connector F or G
and use inside end of twine to pull harness through.
7. Remove wiring harness and gasket (Figure 2, Item 10) from transmission by pulling on wiring harness connector
body (Figure 2, Item 5) with one hand and feeding wiring harness (Figure 2, Item 5) through transmission with
the other hand. Discard gasket (Figure 2, Item 10).
Back to Top
