TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 105 of 620

TM 9-2520-272-40

0015

REMOVE OIL TRANSFER PLATE

1. Remove bolt (Figure 2, Item 8) and washer (Figure 2, Item 9) from oil transfer plate assembly (Figure 2, Item 10).

CAUTION

A 5/16-inch diameter nylon check ball bearing is located in a bore on the top side of the oil

transfer plate assembly, beneath the location of the G2 backup valve assembly. Care should be

taken not to turn the oil transfer plate assembly over and drop the ball into the transmission.

The ball could damage the transmission if it drops into transmission and is not removed.

2. Remove oil transfer plate assembly (Figure 2, Item 10) and place on a work surface away from the transmission.

3. Remove nylon check ball bearing (Figure 2, Item 7) from oil transfer plate assembly (Figure 2, Item 10).

4. Inspect ball bearing (Figure 2, Item 7) and replace if damaged. Put ball bearing (Figure 2, Item 7) in a secure

location.