TM-9-2520-272-40
CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A
TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL
FEBRUARY 2012
TM-9-2520-272-40 - Page 98 of 620
TM 9-2520-272-40
0014
INSTALL WIRING HARNESS ASSEMBLY
NOTE
Wiring harness may be removed/installed whenever the top cover has been removed.
However, when all top components of transmission have been removed, for ease of installation
install the wiring harness after the separator plate has been installed and before the valve
bodies are installed.
Harness should be connected to solenoids and ground after valve assemblies have been
installed.
1. Install new gasket (Figure 3, Item 10) on wiring harness (Figure 3, Item 9). Pull wiring through gasket until
gasket is under wiring harness connector body (Figure 3, Item 5).
NOTE
When the wiring harness was removed, a 30 in. (762 mm) length of twine may have been
installed as an aid to installation. If twine is still tied to connector F or G, pull twine and feed
wiring harness through oil transfer plate assembly. If there is no twine, continue to Step 2.
2. Feed wiring harness (Figure 3, Item 9) into center housing opening (Figure 3, Item 12) and pull wiring harness
(Figure 3, Item 9) through oil transfer plate opening (Figure 3, Item 13).
Back to Top
