TM-9-2520-272-40
CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A
TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL
FEBRUARY 2012
TM-9-2520-272-40 - Page 96 of 620
TM 9-2520-272-40
0014
REMOVE WIRING HARNESS ASSEMBLY
NOTE
Wiring harness can be removed without removal of solenoids or control valve assemblies.
Wiring harness does not have to be removed to remove control valve assemblies.
Transmission is upright on foororworktab
le
.
1. Clean wiring harness connector body (Figure 1, Item 5) and transmission area around connector using a clean,
lint-free cloth and cleaning compound.
2. Remove four screws (Figure 1, Item 6) that attach wiring harness connector body (Figure 1, Item 5) to
transmission. Discard screws (Figure 1, Item 6).
3. Disconnect seven plastic connectors (Figure 1, Item 7) that attach wiring harness (Figure 1, Item 9) to solenoids
(Figure 1, Item 8).
4. Remove bolt (Figure 1, Item 2) and washer (Figure 1, Item 3) that attach harness ground connector (Figure 1,
Item 4) to main control valve assembly (Figure 1, Item 1).
Back to Top
