TM-9-2520-272-40
CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A
TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL
FEBRUARY 2012
TM-9-2520-272-40 - Page 109 of 620
TM 9-2520-272-40
0015
8. Install separator plate (Figure 9, Item 3) over four guide pins (Figure 9, Item 14) and on oil transfer plate
assembly (Figure 9, Item 10).
9. Install f ve 5/16-18 x 1-1/2 inch bolts (Figure 9, Item 6) and f ve washers (Figure 9, Item 5) that attach separator
plate (Figure 9, Item 3), oil transfer plate assembly (Figure 9, Item 10), and new gasket (Figure 9, Item 12) to
transmission.
10.Torque fvebo
l
ts(F
igure9
,I
tem6)to17to20lb-
f
t(23to27N·m)
.
11. Install two 1/4-18 x 1-1/4 inch f anged-head bolts (Figure 9, Item 4) that attach separator plate (Figure 9, Item
3), oil transfer plate assembly (Figure 9, Item 10), and new gasket (Figure 9, Item 12) to transmission.
12.Torque two fanged-headbo
l
ts(F
igure9
,I
tem4)to9to11lb-
f
t(12to15N·m)
.
13.Install 1/4-18 x 1-1/2 inch bolt (Figure 9, Item 1) and washer (Figure 9, Item 2) that attach separator plate (Figure
9, Item 3), oil transfer plate assembly (Figure 9, Item 10), and new gasket (Figure 9, Item 12) to transmission.
14.Torque bolt (Figure 9, Item 1) to 9 to 11 lb-ft (12 to 15 N·m).
15.Remove two 5/16-18 x 3 inch guide pins (Figure 9, Item 14) located outside the edges of the separator plate
(Figure 9, Item 3). Two guide pins (Figure 9, Item 14) that go through the separator plate (Figure 9, Item 3)
will stay installed.
Back to Top
